Filter
Top Products
10
Figure 3: Air tubing fully assembled
All necessary air tubing components are packed with the AUTOSET CS2:
• a 2-metre length of air tubing
• a pressure sensor tube (to measure pressure at the mask) with Luer connectors
• tube clips (to hold the pressure sensor tube onto the air tubing)
• a Proximal cuff (a special connector that attaches the pressure sensor tube into
the main air tubing so that you only need to make one attachment to the mask).
The air tubing is supplied with the Proximal cuff connected. Attach the tube clips
evenly along the air tubing. Press the pressure sensor tube into the tube clips, and
screw the Luer connectors together at the Proximal cuff. Make sure the pressure
sensor tube is not kinked, obstructed or twisted.
NOTE ResMed recommends the following tubing products for use with the AutoSet CS2:
replacement air hose (only) PN 14948; replacement air delivery system (hose, sensor line,
clips, proximal cuff) PN 26909.
MASKS
The following mask systems (supplied separately) are recommended for use with the
A
UTOSET CS2 system. Please refer to the table on page 26 to set up your mask
correctly for use with the A
UTOSET CS2.
Your clinician can explain the features of the masks available, and will discuss the mask
that best suits your needs.
Proximal cuff
Pressure sensor tube
Tube clip
Connect this end
to the mask
Connect this end
to the flow generator
Luer connector
Air tubing
MIRAGE™ FULL FACE
MASK SERIES 2
ULTRA MIRAGE™
MIRAGE VISTA™
MIRAGE ACTIVA™
ULTRA MIRAGE™
FULL FACE MASK
PAPILLON
eng.book Page 10 Friday, November 3, 2006 2:43 PM