Filter
Top Products
15
THE AUTOSET CS2 SYSTEM
ENGLISH
HUMIDAIRE
You will need a Medium size (52cm) air tube to connect the AUTOSET CS2 unit to the
H
UMIDAIRE™ (see Figure 7).
1 Make sure both the HUMIDAIRE and the AUTOSET CS2 are turned off.
Fill the H
UMIDAIRE with water as described in the humidifier manual. Place the filled
water chamber inside the H
UMIDAIRE.
2
Gently detach enough of the tube clips to release the end of the pressure sensor tube
from the A
UTOSET CS2 air tubing.
Connect the A
UTOSET CS2 air tubing to the left connector port on the humidifier, and
the medium (52cm) air tubing to the right connector port. Close the H
UMIDAIRE lid.
3
Place the AUTOSET CS2 on top of the HUMIDAIRE. Do not place the AUTOSET CS2
unit underneath the humidifier. (This is to avoid water spilling into the unit.)
HumidAire
Medium air tubing
AutoSet CS2 air tubing
Pressure sensor tube
eng.book Page 15 Friday, November 3, 2006 2:43 PM