Filter
Top Products
16
4 Connect the free end of the medium air tubing to the AUTOSET CS2.
Connect the pressure sensor tube by twisting the Luer lock onto the A
UTOSET CS2
(see page 12).
5
Connect the mask system to the free end of the long air tubing. The final assembly
should look like this:
6
Switch on the HUMIDAIRE and the AUTOSET CS2.
!
WARNING
Make sure that the power cords and plugs are in good condition and the equipment
is not damaged.
7
Perform the Air Circuit Learn function (see page 26).
For information about filling and maintaining your humidifier, refer to the HumidAire
User’s Manual.
The A
UTOSET CS2 is now ready for use with the HUMIDAIRE. See “Starting Treatment”
on page 21.
eng.book Page 16 Friday, November 3, 2006 2:43 PM