Filter
Top Products
7
QUICK SETUP GUIDE
ENGLISH
QUICK SETUP GUIDE
1
Attach the air tubing and pressure sensor tube to the
AUTOSET CS2
and
mask (page 11).
2
Attach a humidifier if required (page 13).
3
Switch on the
AUTOSET CS2
. Make sure the mask is unblocked.
4
Select the mask setting (page 26).
5
Perform the Air Circuit Learn function (page 26) at first-time use, or if you
are adding or removing a component of the system (eg a humidifier or anti-
bacterial filter).
6
Fit the mask and commence breathing into it. The
S
MART
S
TART
function
should trigger treatment to commence within the first couple of breaths. If
not, press the
Start/Stop
key once to commence treatment (page 21).
NOTE You can observe treatment progress (eg mask leak) via the Treatment screens (page 29).
7
Remove your mask to stop treatment. If
S
MART
S
TOP
is enabled, treatment
will stop automatically. If the
S
MART
S
TOP
function has been disabled, press
the
Start/Stop
key once.
eng.book Page 7 Friday, November 3, 2006 2:43 PM