Filter
Top Products
Be sure to follow the recommended static-free
methods for handling printed circuit boards.
Failure to do so can result in permanent damage to
the equipment.
12. With a Phillips head screw driver, remove four
self tapping screws holding the printed circuit
board.
13. Replace the old printed circuit board with a
new one.
14. Connect the 12-pin molex plug.
15. Connect the 4-pin molex plug.
16. Connect two 1/4” Q.C. wires to P.C. Board.
17. Replace any cable ties that were cut during
the removal procedure.
18. Replace 4 self tapping screws previously
removed.
19. Reinstall the case side, fuel cap, lift bail gas-
ket, case top, and spark plug wires.
TROUBLESHOOTING AND REPAIR
F-41 F-41
EAGLE™ 10,000
PRINTED CIRCUIT BOARD REMOVAL
AND REPLACEMENT (continued)
CAUTION
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC