Filter
Top Products
GS3 2630 Display
CF86321,000039B -19-01JUN11-1/1
BA31779,0000244 -19-26JUL11-1/1
Activating System
CAUTION: While AutoTrac is activated, operator
is responsible for steering at end of path
and collision avoidance.
Do not attempt to turn on (Activate) AutoTrac
system while transporting on a roadway.
After system has been ENABLED, operator must manually
change system to ACTIVATED status when steering
assistance is desired.
Press resume switch. This will initiate assisted steering.
In order to activate system following criteria must be met:
•
Vehicle speed is greater than 0.5 km/h (0.3 mph).
•
Forward vehicle speed is less than 30 km/h (18.6 mph)
•
Reverse vehicle speed is less than 10 km/h (6.0 mph).
•
Vehicle within 45 degrees of desired track.
•
Operator is seated.
•
TCM is on.
•
In reverse AutoTrac will remain activated for 45
seconds. After 45 seconds the machine must be put in
a forward gear before reverse will activate again.
Deactivating System
CAUTION: Always turn off (Deactivate and Disable)
AutoTrac system before entering a roadway.
To turn off AutoTrac, turn the Master Switch
to the OFF position.
AutoTrac system can be made DEACTIVE by following
methods:
•
Turning Master Switch to the OFF position.
•
Turning steering wheel.
•
Slowing to speeds less than 0.5 km/h (0.3 mph).
•
Exceeding forward speed of 30 km/h (18.6 mph)
•
Exceeding reverse speed of 10 km/h (6.0 mph).
•
Toggle STEER ON/OFF button until STEER OFF is
displayed in GUIDANCE VIEW tab.
•
Operator out of seat for more than 5 seconds if using
seat switch or no activity detected by operator presence
monitor for 7 minutes.
The master switch removes power from the EH Valve to
prevent AutoTrac from being unintentionally activated. The
master switch is intended for use on roadways or when
the operator does not want AutoTrac able to be activated.
40-3
090811
PN=52