Filter
Top Products
98
Maintenance
14. Continue to screw in the adjustment screw for tilt
angle.
15. Install the shaft for the link joint and its pins on both
sides.
16. Start the engine and raise the cutting unit to the
transport position.
17. Stop the engine.
18. Install the pins on both sides.
19. Lower the cutting unit to the mowing position.
(Ignition switch, see point 6)
20. Fit the propeller shaft.
21. Check and adjust the cutting unit tilt angle. See
“Tilt angle” on page 100.
Adjustment screw tilt angle
Install the pins on both sides