Filter
Top Products
91
Maintenance
The circuit fuses are located on the circuit board under
a cover on the control panel’s right-hand side. If any of
these fuses trip, only the relevant circuit has no power.
FU1 10 A Red Power take-off’s magnetic clutch
FU2 10 A Red Solenoid valves hydraulic system
FU4 10 A Red Indicators, signal, hazard warning lights
FU5 10 A Red Extra voltage outlet 2
FU6 20 A Yellow Cooling fan
FU7 10 A Red Extra voltage outlet 1
FU8 20 A Yellow Starter motor engagement
FU9 10 A Red Headlight
FU10 7,5 A Brown Lighting traffic kit
FU11 10 A Red Power outlet 12 V
Do not use any other type of fuse when replacing.
A blown fuse is indicated by a burnt connector. Pull the fuse outwards when replacing. A tool is hung on a cable
behind the cover.
The fuses are there to protect the system. If it blows again shortly after replacement, it is due to a short circuit, which
must be fixed before the machine can be put into operation again.
Circuit fuses, location
FU7 FU6 FU1 FU4 FU10
FU8 FU5 FU11 FU2 FU9