Filter
Top Products
119
Lubrication
1. Position the wheels fully to the left.
2. Place a vessel underneath the drain plug.
3. Remove the dipstick. Remove the drain plug on
the oil pan and allow the oil to run into the vessel.
4. Clean and install the drain plug and tighten.
5. Replace the oil filter if necessary. See
“7. Replacing the engine’s oil filter” on page 120.
6. Fill with oil. See “Filling engine oil” on page 118.
7. Run the engine to operating temperature, then
check that there is no leakage from the oil plug or
oil filter.
8. Check the oil level, top up if necessary.
IMPORTANT INFORMATION:
Used engine oil is a health hazard and must not be
disposed of on the ground or in nature; it should
always be disposed of at a workshop or appropriate
disposal location.
Avoid skin contact; wash with soap and water in case
of spills.
Drain plug