Filter
Top Products
99
Maintenance
Setting the cutting height and tilt angle
When a new cutting unit is attached, you need to
adjust the tilt angle and cutting height.
Adjustment must be made in the stated order.
Starting position:
• Check the air pressure in the tyres 100 kPa / 1,0 bar /
14,5 PSI and 150 kPa / 1.5 bar / 21.7 PSI for the pivot
wheels.
• The cutting unit must be lowered on a flat surface.
Cutting height
1. Release the cutting height setting handle.
2. Set the same height at all three setting points.
3. Tighten the cutting height handle by hand.
IMPORTANT INFORMATION:
When replacing the cutting unit, you must readjust
the tilt angle and cutting height.
Left-hand cutting height adjustment
Right-hand cutting height adjustment