Filter
Top Products
68
Driving
5. Activate weight transfer if desired using the switch (30)
on the control panel. The weight transfer position
must always be activated when driving up slopes
and deactivated when driving down slopes.
6. Start the cutting unit as necessary using the switch
for power take-off (22) on the control panel.
The cutting unit can only be started in low speed. If
the switch has already been pulled out and the unit
does not start, press it in and pull it out again
(See safety circuit on page 42).
Braking
Release the drive pedals. The machine slows and is stopped by
the drive system. Do not use the parking brake as the drive
brake.
Quicker braking is possible if you press down the drive pedal for
the opposite direction.
Switch for power take-off and weight transfer