Filter
Top Products
122
Lubrication
Inspection off the oil level
Open the right-hand engine cover and check the level
against the level marking. The level should be between
the MAX and MIN line.
Filling hydraulic oil
Remove the engine cover. See “Engine cover” on
page 79. Fill with hydraulic oil to approximately 60 mm
(2 1/4”) below the strainer’s upper edge.
Changing hydraulic oil
Hydraulic oil and filters should be changed by an
authorised Husqvarna workshop.
IMPORTANT INFORMATION:
Oil level, hydraulic tank
Used hydraulic oil is a health hazard and must not be
disposed of in the ground or in nature.
Replaced filters must be handed in to the workshop
or other allotted place for disposal.
Avoid skin contact; wash with soap and water in case
of spills.