Filter
Top Products
106
Maintenance
5. Undo the locking nut (3) and the lower screw (4) for
the belt tensioner. Remove the belt tensioner.
6. Do not unscrew the centre bolt in the drive shaft.
Remove the rear bearing bridge’s screws (5) and
the spacer washer (6).
7. Cut off the old belts.
8. Insert the new belts through the gap between the
spacer ring and the hydraulic pump and then
through the gap between the bearing bridge and
the mounting. First position one of the belts on the
pump pulley and then on the lower pulley. Repeat
the same procedure with the other belt.
9. Fit the spacer washer (6) for the bearing bridge
and the spacer ring against the pulley with the
accompanying screws (5).
10. Fit the belt tensioning screws with springs and
sleeve. Tighten the screws until the sleeve touches
the frame mounting (4). Tighten the locking nut (3).
11. Check the tension of the belts 25 hours after
changing the belts.
Adjusting the power take-off belts
Tighten the screws until the sleeve touches the frame
mounting (4). Tighten the locking nut (3).
5
6
Belt tensioner and spacer washer
Fitting new power take-off belts