Filter
Top Products
Operating instructions
149 443 85
C 4.74
Operating the implements
Bild_C234
Bild_C267
4 2
3
1
Installing the cardan shafts
Only use shafts suitable and intended for the implement.
These shafts are supplied with the implement. The length
the of the shaft must be adjusted before the first installa-
tion. In case of doubt, please contact our after-sales serv-
ice. Observe installation instructions for the cardan shaft
when installing it.
DANGER
Shut off the engine before the installation. Fit
the protective devices as specified after the
installation.
Removing implements
- Drive the implement to its storage place and lower it
with the front power lift.
- Stop the engine, but do not turn the ignition off.
- Operate all control levers for the front power lift several
times in all directions. This will relieve the pressure in
the hydraulic system.
- Slide the outer ring of the hydraulic couplings (1) back
and disconnect the hydraulic hoses (2).
- Close the protective caps on the hydraulic couplings
(as with item 4).
- Remove the upper link from the pin of the upper link
support.
- Pull the catches (3) up to release the implement pins.
- Lower the front power lift and drive forward carefully.