Filter
Top Products
Operating instructions
149 443 151
C 4.74
General remarks on maintenance
Handling fuels and lubricants
• Fuels and oils must always be handled properly and as
specified by the manufacturer.
• Fuels and oils may only be stored in approved contain-
ers at specified places of storage. They can be inflam-
mable, therefore do not allow them to come in contact
with hot objects or with naked flames.
• Exercise caution when handling fuels - increased dan-
ger of fire. Do not fill any fuels in the vicinity of naked
flames, ignition sparks or hot engine parts. No smoking
when refuelling!
• Before refuelling, shut off the engine and remove the
ignition key. Do not refuel within enclosed spaces. Do
not spill fuels! (use suitable filling aids).
• Exercise caution when handling brake fluid and battery
acid (poisonous and corrosive).
• Only use clean vessels when filling fuel and oil.
• When using fuels, oils and cleaners, follow the safety
and disposal instructions of the manufacturer.
• Always avoid spilling. Eliminate spilled brake fluid
immediately with a suitable binding agent and discard
as specified by regulations.
• Oils, fuels, batteries, brake fluid and filters must be
disposed of separately and as specified by regulations.
• Before beginning lubrication, changing filter or opening
the hydraulic system, clean the area surrounding the
affected part carefully.
• Replaced parts must be discarded in a way friendly to
the environment.
• Observe all local and national laws and regulations.
CAUTION
The penetration of hydraulic oil under pres-
sure into the skin, eg through leaks, is dan-
gerous. If such injuries occur, seek medical
aid.
Safety notes for maintenance
Observe the notes in these maintenance instructions and
the general applicable safety and accident prevention rules!
• Do not allow anyone to stand around where they might
get hurt!
• When starting the engine, the traction and implement
drive must be shut off!
• Start the engine only from the driver’s station. Do not
start the engine by short circuiting the starter terminals,
as the machine could start moving immediately.