Filter
Top Products
Using LO100 44
o
Flow Control: None
o Redirection After BIOS POST: On
5. On HP ProLiant ML150 G2 servers, press the down arrow (↓) key to scroll down to the Console
Redirection option, and press the Enter key to access the submenu.
Verify the following settings:
o Baud Rate: 9600
o Console Type: VT100+
o Flow Control: None
o Continue C.R. after POST: On
6. Press the Esc key to return to the previous screen.
7. Scroll to the I/O Device Configuration option, and press the Enter key.
8. On the ProLiant DL140 G2 and ProLiant DL145 G2 servers, verify that Serial Port is set to BMC
COM PORT.
9. Follow the instructions in the "Network settings (on page 36)" section to set or obtain a valid IP
address.
10. Press the F10 key to save and exit.
After completing the console redirection process, view the boot process remotely from a client computer
through an established telnet session to the IP address of LO100. See your operating system
documentation for instructions on establishing telnet sessions.
When a telnet session is first established, an EMS> prompt appears. If the system is currently booting, the
boot process is displayed. If you do not want to view boot, press the Esc+( keys. If the system is in the
Operating System or off, the EMS> prompt appears, but disappears after pressing Enter.
To redirect the console to the telnet session and view the boot process, press the Esc+Q keys in the telnet
session during server boot. If you reset the server using the telnet connection and press the Esc+Q keys,
the boot process might not appear immediately. The boot process appears after the server resets. To end
the session, press the Esc+( keys.
NOTE: If you encounter problems logging in to the remote console, be aware that some telnet
programs might require you to enable their send line feed at end of line option. If
the remote console does not respond to the Enter key, try setting this option in your telnet
program.
NOTE: You must follow the instructions in the "Network settings (on page 36)" section to
configure the network access properly.
Linux console redirection
In the remote console and servers with the Linux operating system, you can enable a remote login on
ttyS0 by making the following changes to the BIOS Setup Utility and boot documents.
1. On the ProLiant DL140G2, ProLiant DL145G2, and ML150 G2 servers, verify or change the
following:
Console Redirection:
Verify the following settings:
o Baud Rate: 9600