Filter
Top Products
Using LO100 27
• The start command causes a target to change state to a higher run level.
• The stop command causes a target to change state to a lower run level.
• The version command queries the version of the CLP implementation or other CLP elements. For
example:
/./map1/-> version
Version 1.00
/./map1/-> cd firmware
/./map1/firmware/-> version
Version 1.00
/./map1/firmware/-> show
/./map1/firmware
Targets
Properties
fwversion=0.59
Verbs
cd
version
exit
show
reset
load
help
/./map1/firmware/-> show fwversion
fwversion=0.59
/./map1/firmware/-> fwversion
Invalid command
/./map1/firmware/->
Specific commands
CLP syntax for specific commands is found in the sections that also describe the functionality through the
Web interface.
IPMI 2.0 support
LO100 supports the industry-standard IPMI 2.0. The IPMI specification defines standardized, abstracted
interfaces that can be used for monitoring and control functions that are built in to the platform hardware.
In addition to supporting the mandatory commands for IPMI 2.0, the following additional IPMI 2.0
features are supported by LO100:
• Additional IPMI 2.0 commands
o Get Channel Cipher Suites
o Set/Get Channel Security Keys
o Suspend/Resume Payload Encryption