Filter
Top Products
Using LO100 26
The first line of information returned by the show command is the current context. In the example, /
is the current context. Following the context is a list of subtargets (Targets) and properties (Properties)
applicable to the current context. The verbs (Verbs) section shows what commands are available in
this context.
The show command can also be specified with an explicit or implicit context and a specific
property. An explicit context is /map1/firmware and is not dependent on the current context. An
implicit context assumes that the context specified is a child of the current context. If the current
context is /map1, then a show firmware command displays the /map1/firmware data. If a
property is not specified, then all properties are shown.
• The load command moves a binary image from a URL to the map. The load command is used to
take a binary image from a specific source location (specified as a URL) and place it at the specified
target address. In a remote management processor implementation, the firmware downloads a full
image file using TFTP from the specified location and programs flash with the image.
In a remote management processor implementation, /map1/firmware is a valid target.
The load command supports usage only with the following options.
o -source <location>—This option must be specified.
o (h)elp—this option appears on the command line, the command ignores all options and
properties except -output (for terse or verbose output). These options are only valid for this
command when the -help option is used.
o source <value>—This option specifies the target from which it will transfer the binary image.
The value specified must be a valid URL. The expected format is
//tftpserverip/path/filename. This option is required in the command line every time
the load command is executed unless -help is used. The file must be an uncompressed firmware
image file that you create using the DOS ROMPAQ utility found on the Lights-Out 100 Firmware
Upgrade Diskette Utility available for download from the HP website
(http://www.hp.com/servers/lights-out
).
To create the uncompressed image file, enter the following command from DOS:
ROMPAQ /D <infile> <outfile>
where <infile> is the ROMPAQ firmware image file and <outfile> is the filename for the
uncompressed binary image file.
The load command returns any status data on the first lines. After the status data appears, one of
the following lines of text displays on the next line:
<URL> transferred to <target address> (if the file is transferred)
<URL> not transferred (if the file is not transferred)
Example:
load -source //192.168.2.1/pub/firmwareimage.bin -oemhpfiletype csr
//192.168.2.1/pub/firmwareimage.bin transferred to
/map1/firmware/fullimage
• The reset command causes a target to cycle from enabled to disabled and back to enabled.
• The set command sets a property or set of properties to a specific value. set property = new
value is the standard syntax for the set command.
The set command is used to change any changeable property. If the current directory does not
contain the property you want to change, the target of the property must be specified before entering
the property you want to change.