Filter
Top Products
Using LO100 36
a.
Press the down arrow (↓) key to scroll to the View BMC System Event Log submenu. Press the
Enter key.
b. Use the plus (+) or minus (-) keys to scroll through the events.
7. Press the Esc key to return to the previous screen, or press the F10 key to save the changes and exit
Setup.
Network settings
You can view and modify network settings for LO100 using a web browser, CLP, or the BIOS Setup
Utility. If you change the IP address, the connection to the server terminates. You must reconnect to the
server using the new IP address.
Configuring network settings using a web browser
The Network Settings screen displays IP address, subnet mask, and other TCP/IP-related settings. From the
Network Settings screen, you can enable or disable DHCP, and you can configure a static IP address for
servers not using DHCP. You can view and modify the network settings when logged in as either OEM or
administrator (admin).
To modify the network settings, click Network Settings on the browser main menu navigation bar, enter
the new settings, and click Apply.
Configuring network settings using the CLP
1. Log in to LO100 CLP as described in the "Logging in to LO100 (on page 28)" section.
2. At the command prompt, enter cd map1/nic1.
3. Configure the network settings by entering the following: set <network property>=<new
setting>. Configurable valid network properties are:
o networkaddress specifies the IP address for the NIC. This setting is dynamic.
o oemhp_nonvol_networkaddress specifies the IP address stored in non-volatile memory.
o oemhp_mask specifies the subnet mask for NIC. This setting is dynamic.