Filter
Top Products
Using LO100 31
Controlling server power from a browser
The Virtual Power screen displays current power status, how long the server has been powered up, and
reason for the last server restart. To display the Virtual Power screen, click Virtual Power on the main
menu navigation bar.
To modify Chassis Actions, select the desired Power Control Option in the Chassis Actions section, and
click Apply to initiate the action.
To identify the server in the rack and illuminate the UID (LED on the front panel of the server), select the
length of time you want the UID to stay illuminated on the Chassis Locator list, and click Identify.
NOTE: The UID is only available on HP ProLiant DL140 G2 and ProLiant DL145 G2 servers.
Controlling server power through the CLP
1. Log in to LO100 CLP as described in the "Logging in to LO100 (on page 28)" section.
2. Change to the system1 target by entering cd system1.
3. To power on the server, enter start /system1. For example:
/./system1/> start /system1
System1 started.
4. To power off the server, enter stop /system1. For example:
/./system1/> stop /system1
System1 stopped.
The -force option can also be used with the stop command. This option forces the
implementation to stop the target, ignoring any policy that might cause the implementation to
normally not execute the command. In remote management processor implementation, this process is
equivalent to a hard power down.
5. To reset the server, enter reset /system1. For example:
/./system1/> reset
System1 reset.