Filter
Top Products
SECTION 6 GPIB
6-59
(7) Sweep
• Because the sweep marker of the MG3641A/MG3642A is always on, the sweep marker ON/OFF switching
commands (SF4, SO4, SF5, and SO5) are invalid.
• Stepping up (SF8 and SO8) and down (SF9 and SO9) cannot be done during manual sweep.
• The sweep start point presets (SFA and SOA) and stop point presets (SFB and SOB) cannot be interchanged
because the MG3641A/MG3642A does not have an equivalent function.
• The AF frequency sweep cannot be executed because the MG3641A/MG3642A does not have this function.
• The memory sweep function cannot be interchanged because sweep parameters and memory are managed
completely differently.
(8) Memory
• Because the MG3641A/MG3642A does not have a frequency memory, the command relating to the frequency
memory (FQ) cannot be interchanged.
(9) Other non-interchangeable functions
• Commands relating to phase modulation cannot be interchanged because the MG3641A/MG3642A does not
have a phase modulation function.
• The trigger program editing function cannot be interchanged because the trigger program is constructed differ-
ently.
• Functions relating to SRQ are not interchangeable.