Filter
Top Products
64 Local Operation
Recalling the Factory Default Values
You can recall the factory default values (see Table 4-6) for all modules by pressing:
.
As soon as the Enter key is pressed, the Electronic Load will be set to its factory default values. Note that the Electronic
Load is also set to the factory default values when the *RST common command is sent via the GPIB (see the Programming
Reference Guide).
If you also want the factory default settings to be the "wake-up" settings, you can recall them as described above and then
press:
(blue shift key) (shifted)
.
Now, when power is turned off and on, the Electronic Load will be set to the factory default settings.