Filter
Top Products
Installation 35
3
Installation
Introduction
This chapter discusses how to install and make connections to the rear panel of your Electronic Load. A turn-on checkout
procedure as well as application considerations for specific operating modes are also discussed.
Inspection
When you receive your Electronic Load, inspect it for any obvious damage that may have occurred during shipment. If there
is damage, notify the carrier immediately and notify the nearest Agilent Sales Office. Warranty information is printed on
the inside front cover of this manual.
Save the shipping cartons and packing materials in case the unit must be returned to Agilent Technologies in the future. If
you return the unit for service, attach a tag identifying the owner and model number. Also include a brief description of the
problem. In addition to this manual, check that the following items have been received with your Electronic Load:
Power Cord
Your Electronic Load was shipped with a power cord for the type of outlet used at your location.
If the appropriate cord was not included, refer to Figure 3-1 for the part number and order option
for your type of cord. Contact your nearest Agilent Sales and Service Office to obtain the
correct cord. Refer to “Check Line Voltage” to check the line voltage selection and fuse type.
Quick Disconnect
Mating Plugs
A 10-pin mating plug for the control connector and a 4-pin mating plug for the trigger connector
are shipped with the Electronic Load. These mating plugs are discussed later in this chapter.
Programming
Reference Guide
This guide enables you to use HPSL commands to remotely control your Electronic Load from a
controller using the HPSL programming language.
Change Sheet
Change sheets may be included. Make corrections in the manual accordingly.
Figure 3-1. Power Cord Configurations