Filter
Top Products
Assembly 17
MAN0160 (Rev. 2/22/2006)
Install Slow Moving Vehicle Sign
NOTE: If installing optional hydraulic kits that include
double relief valves on Model SA or the complete
hydraulic system for Model H, do not install bracket
(5, Step 1) at this time. Begin with Step 2.
Refer to Figure 12.
1. Place bracket (5) to top of boom and secure with
two carriage bolts (34), flat washers (36), lock wash-
ers (37), and hex nut (38).
2. Attach SMV socket (6) to bracket (5) using two
carriage bolts (34), flat washers (36), lock washers
(37), and hex nuts (38).
3. Attach SMV sign (8) to SMV sign bracket (7)
using two round head screws (32) and nuts (33).
4. Insert sign and bracket assembly into socket (6)
to display SMV sign.
5. Bracket - SMV Sign
6. Socket, SMV Emblem
7. SMV Bracket
8. Slow Moving Vehicle Sign
32. Screw, Round Head 1/4 NC x 1/2
33. Nut, Hex 1/4 NC
34. Bolt, Carriage 5/16 NC x 1-1/4
36. Washer, Flat 5/16 Standard
37. Washer, Lock 5/16
38. Nut, Hex 5/16 NC
Figure 12. Slow Moving Vehicle Sign Installation
Proceed to page listed below to complete desired blade assembly.
M = All Manual: Angle, Tilt & Swing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
MT = Manual Swing & Angle: Hydraulic Tilt for tractors with at least one hydraulic port . . 18
MA = Manual Swing & Tilt: Hydraulic Angle for tractors with at least one hydraulic port . . 19
SA = Manual Tilt: Hydraulic Swing & Angle for tractors with at least two hydraulic ports . . 19
TA = Manual Swing: Hydraulic Tilt & Angle for tractors with at least two ports. . . . . . . . . . 19
H = All Hydraulic: Angle, Tilt & Swing for tractors with three hydraulic ports . . . . . . . . . . 23
5
6
7
8
34
33
32
37
36
36
37
38
34
CD5979-5