Woods Equipment RB850-4 Lawn Mower Accessory User Manual


 
28 Assembly
MAN0160 (Rev. 2/22/2006)
Install Skid Shoe Kit 18296 (Optional)
1. Attach the bracket (1) to the blade with four cap
screws (8) and lock nuts (9) as shown in Figure 31.
Torque hardware to 85 lbs.-ft (115 N-m).
2. Insert skid assembly (3) into tube of bracket (1)
and secure with klik pin (4).
3. The cutting edge height is controlled by adjusting
the skid shoes with a combination of spacers (2) and
washers (10).
4. To raise the cutting edge, place spacer(s) (2) and
washer(s) (10) under skid shoe bracket (1).
To lower the cutting edge, place spacer(s) (2) and
washer(s) (10) on top of skid shoe bracket (1).
NOTE: Before using, make sure that skid shoes
rotate freely. If not, work them loose to avoid prema-
ture wear. Rotating shoes will last longer.
Grease at assembly and after every eight hours of
use.
Figure 31. Skid Shoe Installation
A. Skid Shoe Kit
1. Bracket, Skid Shoe
(includes item 11)
2. Sleeve, 1.26 x 1.66 x .75
3. Skid
4. Pin, Klik 7/16 x 2
8. Cap Screw, 1/2 x 1-1/4 GR5
9. Nut, Flanged Lock 1/2 NC
10. Washer, Flat 1-1/4 Standard