Woods Equipment RB850-4 Lawn Mower Accessory User Manual


 
20 Assembly
MAN0160 (Rev. 2/22/2006)
Models: MT & TA
Install Hydraulic Tilt Kit 1004871
Refer to Figure 16
NOTE: Remove tilt lock pin (1) before installing
hydraulic tilt kit. See Figure 13 on page 18 for lock pin
location
1. Attach hydraulic cylinder (1) to blade assembly
and pivot assembly as shown. Secure with pins sup-
plied with the cylinder.
2. Install adjustable elbows (2) and hoses (6) to cyl-
inder.
3. Attach hose holder (4) to A-Frame using carriage
bolt (18), flat washer (19), and lock nut (20). For mod-
els with hydraulic angle (TA) proceed to page 21 for
hose routing.
4. Attach hose clamp (3) to hose support (5) using
cap screw (15), lock washer (16), and hex nut (17).
Do not tighten at this time.
5. Remove cap screw (21), lock washer (23), and
flat washer (22) from forward position on retaining cap
as shown.
6. Position hose support (5) over hole and reinstall
hardware.
7. Route hoses as shown in Figure 17.
8. Position hose support (5) and tighten hardware.
9. Place hoses in hose clamp (3) and tighten hard-
ware. Leave adequate slack in hoses to allow for tilt
and angling of blade.
1. Hyd Cylinder 3-1/2 x 8
2. Elbow, 3/4 ORBM 3/4 JICM 90
3. Hose Clamp 5/8
4. Hyd Hose Holder
5. Link, Hose Support
6 Hose, 3/8 138 1/2 NPTM x 3/4 JICF
7. Binding Strap 14-1/2
15. Cap Screw 5/16 NC x 1 GR5
16. Washer, Lock 5/16
17. Nut, Hex 5/16 NC
18. Bolt, Carriage 3/8 NC x 1-1/4 GR5
19. Washer, Flat 3/8 Standard
20. Nut, Lock 3/8
21. Cap Screw 3/4 NC x 2-1/4 GR5
22. Washer, Flat 3/4 SAE
23. Washer, Lock 3/4
Figure 16. Tilt Kit Installation with Manual
Angle Control
Figure 17. Tilt Kit Hose Routing
2
1
2
3
2
2
1
7
1
6
3
5
6
1
7
1
8
4
1
9
2
0
C
D
5985
CD5993