Filter
Top Products
Assembly 23
MAN0160 (Rev. 2/22/2006)
Model: H
Install Hydraulic Cylinders
Refer to Figure 22.
1. Place hydraulic angle arm (1) on boom as shown.
2. Secure into position using three cap screws (33),
lock washers (35), and flat washers (34).
3. Attach hydraulic angle cylinder (5) to boom and
hydraulic angle arm assembly as shown. Secure with
pins supplied with the cylinder.
4. Attach hydraulic offset cylinder (5) to A-Frame
and boom as shown. Secure with pins supplied with
the cylinder.
5. Attach hydraulic tilt cylinder (4) to pivot assembly
and blade as shown. Secure with pins supplied with
the cylinder.
6. Install two adjustable elbows (6) to each of the
hydraulic cylinders as shown.
7. Install two hoses (15) to the hydraulic tilt cylinder.
NOTE: Do not install angle and offset cylinders hoses
at this time.
8. Attach hose holder (9) to back side of A-Frame as
shown. Secure using one carriage bolt (28), flat
washer (29), and lock nut (30).
Figure 22. Hydraulic Cylinder Installation
Angle
Tilt
Offset
1
5
6
4
15
6
33
35
34
6
5
9
29
30
28
CD5983-2
1. Hyd Angle Arm Assembly
4. Cylinder, Hyd 3-1/2 x 8
5. Cylinder, Hyd 3-1/2 x 16
6. Elbow, 3/4 ORBM 3/4 JICM 90
9. Hyd Hose Holder
15. Hose, 3/8 138 1/2 NPTM 3/4 JICF
28. Bolt, Carriage 3/8 NC x 1-1/4 GR1
29. Washer, 3/8 Flat
30. Nut, Lock 3/8 NC
33. Screw, HHCS 3/4 NC x 3 GR5
34. Washer, Flat 3/4 SAE
35. Washer, Lock 3/4