Woods Equipment RB850-4 Lawn Mower Accessory User Manual


 
22 Assembly
MAN0160 (Rev. 2/22/2006)
Model: SA or Optional Offset Kit 1004872
Install Hydraulic Offset Cylinder
Refer to Figure 20.
NOTE: Hydraulic angle cylinder must be installed with
this offset kit.
1. Install hydraulic angle kit as instructed on page
19. Remove 84” hoses from angle cylinder if previ-
ously installed.
2. Attach hydraulic cylinder (3) between A-Frame
and boom as shown in Figure 20. Secure with pins
supplied with the cylinder.
3. Install adjustable elbows (4) to cylinder (3).
4. Remove bracket (1) and hardware if previously
installed.
5. Install 45–degree elbows (5) into relief valves (2).
Position elbows outward as shown.
6. Attach both valve blocks (2) and bracket (1) to
boom using two cap screws (21), four flat washers
(22), two lock washers (23), and hex nuts (24).
7. Attach hoses (10) to elbows (5) as shown.
8. Attach hoses (8 & 9) to back side of relief valves
(2) and offset cylinder (3) as shown in Figure 21.
9. Attach hoses (6 & 7) to back of relief valves (2)
and angle cylinder as shown in Figure 21.
1. Bracket - SMV Sign
2. Valve Double Relief 1600 psi
3. Hyd Cylinder 3-1/2 x 16
4. Elbow, 3/4 ORBM 3/4 JICM 90
5. Elbow, 3/4 JICM x 3/4 ORMB 45
6. Hose, 3/8 18 3/4 ORBM 3/4 JICF
7. Hose, 3/8 24 3/4 ORBM 3/4 JICF
8. Hose, 3/8 28 3/4 ORBM 3/4 JICF
9. Hose, 3/8 34 3/4 ORBM 3/4 JICF
10. Hose, 3/8 66 1/2 NPTM 3/4 JICF
11. Binding Strap, 14-1/2
21. Cap Screw, 5/16 NC x 5-1/2 GR5
22. Washer, Flat 5/16 Standard
23. Washer, Lock 5/16
24. Nut, Hex 5/16 NC
Figure 20. Offset Kit Installation
Figure 21. Hose Connection
6
7
4
8
9
11
2
5
10
21
22
3
1
24
23
22
CD5982
Offset
Angle
C
D
B
A
B
A
C
D
CD5997
To Tractor
Offset Couplers
To Tractor
Angle Couplers