Filter
Top Products
36 Dealer Check Lists
15914 (Rev. 5/11/2007)
DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
Inspect cutter thoroughly after assembly to be certain it
is set up properly before delivering it to customer. The
following check list is a reminder of points to inspect.
Check off each item as it is found satisfactory, correc-
tions made or services performed.
___ Check all bolts to be sure they are tight.
___ Check that all cotter pins are properly installed
and secured.
___ On pull-type cutter, make sure pin to prevent
crank detachment is installed.
___ Check that PTO shaft is properly installed.
NOTICE
■ Gearbox was not filled at factory. It must be
serviced before operating cutter. (See page 18.)
Failure to service will result in damage to gearbox.
___ Check that gearbox is properly serviced and
seals are not leaking.
___ Lubricate cutter.
___ Check that blades have been properly installed.
DELIVERY CHECK LIST
(DEALER’S RESPONSIBILITY)
___ Show customer how to make adjustments.
___ Explain importance of lubrication to customer and
point out lubrication points on cutter.
___ Point out safety features and options.
___ For mounted units, add wheel weights, ballast in
front tires, and/or front tractor weight to enhance
front end stability. A minimum 20% of tractor and
equipment gross weight must be on front tractor
wheels. When adding weight to attain 20% of
tractor and equipment weight on front tractor
wheels, you must not exceed the ROPS weight
certification. Weigh the tractor and equipment. Do
not estimate!
___ Give Operator's Manual to customer and recom-
mend that customer become familiar with all sec-
tions, especially the safety information.
___ Explain to customer that when transporting cutter
on road or highway, day or night, safety devices
should be used to provide adequate warning to
operators of other vehicles.