Filter
Top Products
Assembly 31
15914 (Rev. 5/11/2007)
Figure 24. Tongue and H-Frame Assembly
Tongue Installation for D80-2 Pull-Type
Cutter
Attach compression bracket (7) to front of gearbox
stand with lock washers (20) and nuts (21), see Figure
24.
Align holes in tongue (1) to bottom hole of mast plate
(6) and insert bushing (14) through the holes, then
place washer (13) on bolt (12) and insert through mast
plate, bushing and tongue. Install lock washer (15) over
bolt and attach with nut (16).
Support tongue by attaching jack (27).
Attach compression member (4) to compression
bracket (7) with clevis pin (25) and cotter pin (17), then
attach front end to tongue with bolt (19), lock washer
(20) and nut (21). The compression member setting
must be adjusted when the cutting height is set.
Align H-frame (5) to tongue (1) and attach with clevis
pin (18) and two cotter pins (17).
Place key in gearbox input shaft, loosen clamp bolt (11)
on rear of driveline, and slide driveline onto gearbox
input shaft. Tighten clamp bolt and install cotter pin (30)
through driveline and input shaft. Snap rear tether
30
32
32
31
28
29
28
10
9
11
8
12
13
14
26
20
21
7
17
25
6
21
20
24
23
27
17
22
5
4
20
21
15
16
19
18
17
3
2
1
CD3823A
1. Tongue
2. Tongue lug
3. Tongue adjustment bracket
4. Compression member
5. H-Frame
6. Mast plate
7. Compression bracket
8. Rear U-joint shield
9. Carrier bearing housing
10. Drive shaft shield
11. Clamp bolt
12. 5/8 x 2-1/4" Bolt
13. 5/8" Flat washer
14. 5/8 x 7/8 x 11/16" Bushing
15. 5/8" Lock washer
16. 5/8" Hex nut
17. 3/16 x 1" Cotter pin
18. 5/8 x 6-3/4" Clevis pin
19. 1/2 x 1-3/4" Bolt
20. 1/2" Heavy lock washer
21. 1/2" Heavy hex nut
22. 1/2 x 5-1/2" Clevis pin
23. 1/2 x 5-1/2" Bolt
24. 1/2" Schedule 40 x 3-9/16"
pipe
25. 1/2 x 2" Clevis pin
26. 1/2 x 1-1/4" Bolt
27. Parking jack
28. 3/8 x 1" Bolt
29. 3/8" Lock washer
30. 1/4 x 3" Cotter pin
31. 3/8" Flanged lock nut
32. Tether chain