Filter
Top Products
Owner Service 19
15914 (Rev. 3/23/2007)
Figure 8. Lubrication Points
Blade Removal
Rotate crossbar until blade pin assembly is directly
below access hole in rear of cutter frame. Remove bolt
(1) and blade pin clip (2). Slide keyhole plate (3) out of
blade pin groove and remove. Remove spacers and
drive pin out of crossbar. See Figure 7.
Ref
No Description Frequency
1 Tailwheel Hub (Towed Model) 10 hrs
2 Tailwheel Pivot Arm 8 hrs
3 Tailwheel (Mounted Model) 8 hrs
4 Blade Spindle - Access through
hole in end of belt shield (right);
Remove left belt shield (left) 10 hrs
5 Belt Idler - Access through hole
in top of belt shield (right);
Remove left belt shield (left) 50 hrs
6 Gearbox: Fill with EP90 gear
lube Check Daily
7 Rear U-Joint 8 hrs
8 Slip Joint (Mounted Model) -
Apply grease to all four sides
of shaft 8 hrs
9 Front U-Joint 8 hrs
10 Center U-Joint (Towed Model) 10 hrs
11 Driveline Carrier Bearing
(Towed Model) 10 hrs
12 Slip Joint (Towed Model) -
Apply grease to all four sides
of shaft 10 hrs
13 Height Adjustment Pivot Block Occasionally
14 Height Adjustment Crank Occasionally