Filter
Top Products
32 Assembly
15914 (Rev. 5/11/2007)
chain (32) around the compression link to prevent driv-
eline shield rotation.
Align driveline in H-frame and insert clevis pin (22)
through H-frame and carrier bearing (9). Attach by
inserting two cotter pins (17) in clevis pin (22). Snap
middle tether chain (32) around H-frame to prevent
driveline shield rotation.
Attach rear universal joint shield (8) to gear stand as
shown with bolts (28) and nuts (31). Place forward driv-
eline shield (10) over H-frame and attach with lock
washer (29) and bolt (28).
Attach pipe (24) to H-frame using bolt (23), lock washer
(20) and nut (21). Attach front tether chain (32)
securely to tractor.
Optional Hydraulic Installation for D80-2
Pull-Type Cutter
Remove the crank (7) from pivot link holder (6), insert
pivot link (5) into pivot link holder (6), then install the
crank and cotter pin (8), see Figure 25.
Remove bolt (2) from H-frame, install hydraulic hose
holder (3), and install bolt.
Install hydraulic cylinder (9) using clevis pins (11), then
route hose through hose holder (3).
Figure 25. Optional Hydraulic Lift Assembly
1. Pivot link kit
2. 1/2 x 5-1/2" Bolt
3. Hose holder
4. 1/2" Hex nut
5. Pivot link
6. Pivot link holder
7. Crank
8. 1/4 x 1-1/2" Cotter pin
9. Cylinder
10. H-Frame
11. Clevis pin
12. Pivot nut