Filter
Top Products
B
A
C
D
Replace (throw-away) the MicroClean filter cartridge
every 6 months, or as needed! DO NOT reuse this
cartridge for any reason!
Loosen filter nut (A) to provide clearance,
then remove used MicroClean Plus filter
cartridge (steps B-C). Remove suction
fitting filter (D) and clean with mild liquid
soap solution and warm water, then reinstall
over suction fitting.
TURN POWER TO HOT TUB OFF!
Submerge new filter cartridge in spa and tilt
each end upward to remove most of the
air bubbles trapped inside the filter.
E
1. Install new filter cartridge, then tighten filter nut until
it just touches filter face. DO NOT OVERTIGHTEN!
2. Turn power to hot tub back on.
Filter
Nut
Filter
Nut
Trapped
Air
Bubbles
Replace MicroClean Plus
cartridge every 6
months, DO NOT
Reuse for any reason!
A
B
B
C
A
D
A
C
-
and reused for up to two years but does not maintain the same water
13.2 Draining And Relling
About every 3 to 6 months, you will should replace the hot tub’s water.
The frequency depends on a number of variables including the amount of
time for a change when you cannot control sudsing and/or you can no
water balance measurements are all within the proper parameters.