Attention New Hot Tub Owner!
Congratulations on the purchase of your new Sundance® hot tub! The following is
a list of automated functions performed by your hot tub. These functions are listed
below in an attempt to suppress any operational concerns you may have during the
-
mendations you should observe on a regular basis to protect your new investment.
Automated Spa Operations
Your new hot tub is equipped with an automated “blow-out” cycle that clears all
turn on for a period of one minute, then go off. Then pump 1 will turn on and run
for one minute to complete the blow-out cycle. Be aware, the factory programmed
blow-out cycle cannot be canceled or altered!
Maintain Healthy Spa Water
Always maintain your hot tub’s water chemistry within the following parameters as
pH 7.4 - 7.6
Free Chlorine 3.0 - 4.0 ppm
Free Bromine 2.0 - 4.0 ppm
Total Alkalinity 100 - 120 ppm
Calcium Hardness 150 -250 ppm
Refer to for additional information.
Required Filter Maintenance
Your new hot tub is equipped with an advanced MicroClean
system that provides unsurpassed water quality! To ensure maximum water quality
necessary. Attempts to reuse
hot tub. See
Required Water Replacement
You should replace the hot tub’s water every 3 to 6 months. The frequency
depends on a number of variables including frequency of use, number of users,
change when you cannot control sudsing and/or you can no longer get
the normal
all within the proper parameters. See page 59 for additional information.