12.0 Programming Instructions
12.1 Programming Filter/Circulation Pump Run Time
The Sentry control system allows you to easily adjust two separate as-
(CYCLE)
“Circ” At this time the system is ready to ac-
SELECT) button once. The previously programmed
UP or DOWN buttons to adjust the start time in 30-
minute increments.
SELECT) buttons to program duration.
UP or DOWN buttons to program the duration time in 1
hour increments.
DISPLAY) button to save changes and recall the main
seconds, all changes are recorded and the screen automatically
returns to the standard water temperature display.
Note: When the standard mode is selected (sec. 11.3), the lter/
circulation pump automatically turns on for a heat call regardless of the
pump’s programmed start time and duration.
12.2 Programmable Filter Cycles
The control
Note: When “Standard” mode is selected (sec. 11.3) and the lter/
circulation pump is set to the factory default duration of 24-hours
(sec. 12.1), each cycle is displayed on the main control panel, when
running, but no apparent change of operation will occur. However,