Sundance Spas Maxxus Hot Tub User Manual


  Open as PDF
of 90
 

4. Activate Jets Pumps
Turn on all jet(s) pumps and blower to ensure proper mixing
when adding start up chemical in step 5.
5. Add Start-Up Chemicals
Add the hot tub water chemicals as recommended by your Sundance

(page 59) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 
 To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended

inside cover of this manual. cannot be stabilized,
perform the decontamination procedure steps 9-15 on the following
page. Note: the “decontamination procedure” steps 9-15 should
also be used after the hot tub has been “Winterized” (sec. 13.7) or
has been sitting without power for an extended period.
7. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow

 -
COOLER 
or WARMER 
-
ture, simply press COOLER or WARMER within 5 seconds. The set
temperature increases or decreases by one degree each time one of
these buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
 previous next