Filter
Top Products
PAGE 36 — DCA-800SSK (STD) — OPERATION AND PARTS MANUAL — REV. #4 (06/03/10)
Generator Output Voltages
A wide range of voltages are available to supply voltage for
many different applications. Voltages are selected by apply-
ing jumpers (6) to the
voltage change-over board
(Figure 15).
To obtain some of the voltages as listed in Table 7 (see
below) will require a fine adjustment using the
voltage regu-
lator
(VR)
control knob
located on the control panel.
Voltage Change-Over Board
The
voltage change-over board
(Figure 15) is located on
the control box, behind the generator control panel. This
board has been provided for ease of voltage selection.
Figure 15. Voltage Change-Over Board
240V Configuration
DCA-800SSK — GENERATOR OUTPUTS
Generator Amperage
Tables 8 and 9 describe the generator’s current output capa-
bility for both 1Ø-phase and 3Ø phase applications.
Ø1—sgnitaRerepmArotareneG.8elbaT
WKV931V042V772V084
0480202140106
001915103162051
061138184714142
022241,1266375133
082454,1248037124
043567,1220,1688115
004770,2302,1240,11
06
064883,2383,1991,1296
025007,2465,1553,1287
085110,3447,1115,1278
046323,3529,1766,1269
Ø3—sgnitaRerepmArotareneG.9elbaT
WKV042V084
0402106
001103051
061184142
022266133
082248124
043220,1115
004302,1106
064383,1296
025465,1287
085447,1278
046529,1269
segatloVelbaliavArotareneG.7elbaT
esahP-eerhT
V802V022V042V614V044V084
esahP-elgniS
V021V721V931V042V452V772
NEVER attempt to place jumper plates on the
voltage
change-over board
while the generator is in operation.
There exists the possibility of
electrocution, electrical
shock or burn, which can cause severe bodily harm
or even death!
CAUTION - CHANGING JUMPER PLATES