Filter
Top Products
22
Section 4 Maintenance and Lubrication
RCR2584 Rotary Cutter 312-459M 7/14/08
Land Pride
Table of Contents
Lubrication
50
Multipurpose
spray lube
Multipurpose
grease lube
Multipurpose
oil lube
Intervals at which
lubrication is required
Lubrication
Legend
24
Tailwheel Spindle Tube
Type of Lubrication: Grease
Quantity = 6 pumps
13753
Tailwheel Hub
The tailwheel hub is equipped with a relief hole located
directly opposite the grease fitting. The relief hole re-
leases pressure from inside the hub casting when it is
greased. The hub should be greased until grease purg-
es from the relief hole.
Type of Lubrication: Multipurpose Grease
Quantity = Until grease purges from the relief hole
13753
8
Gearbox
Check oil level in the gearbox by removing the side plug in
the gearbox case. If the oil level is low, remove the top plug in
the gearbox case and fill with EP90 oil until oil flows from the
side port of gearbox case. Reinstall plugs and tighten.
Type of Lubrication: EP90 Oil
Quantity = fill until oil flows from the side port of gearbox
case.
NOTE: Do not overfill! Cutter should be level when
checking oil.
8
14269