Filter
Top Products
19
Section 3 Adjustments
7/14/08
RCR2584 Rotary Cutter 312-459M
Land Pride
Table of Contents
Deck Attitude Adjustment
Refer to Figure 3-7:
This adjustment is very important. With the deck posi-
tioned at this attitude, the blades will be cutting material
only at the front of the cutter. If the deck is level, or the rear
of the cutter is lower than the front, the blades are subject
to continuous material flow which results in additional
blade wear and horsepower loss as well as more frequent
blade sharpening.
Lift-Type
1. Place tractor and mower on level surface.
2. Raise the mower to approximate desired cutting
height with tractor hydraulic lever.
3. Loosen and remove bolts on adjusting brackets and
position tailwheel.
4. Lower the cutter slowly until mower is 1” lower at front
than at rear. Set stop on tractor lift quadrant so the cut-
ter can be returned to same height.
5. Adjust top link. Refer to Figure 3-2.
Trail-Type
1. Place tractor and mower on level surface.
2. Retract ratchet jack or hydraulic cylinder to raise rear
wheels off of ground.
3. Remove clevis pins from level rod assembly and axle.
4. Unscrew (only) short level rod weldment from level rod
assembly approximately 1/4”, and reassemble to axle
weldment.
Best Deck Attitude for Cutting
Figure 3-7
14392