Filter
Top Products
17
Section 3 Adjustments
7/14/08
RCR2584 Rotary Cutter 312-459M
Land Pride
Table of Contents
Cutter Height Adjustment
Single Tailwheel
Refer to Figure 3-4:
1. If the cutting height is too high or too low, the tailwheel
must be adjusted as follows:
a. Use the tractors 3-point hydraulic control to lift the
cutter such that the tailwheel clears the ground.
b. Remove attaching hardware; 1/2” -13 x 1 1/2"long
bolt (#1), 1/2” lock washer (#2) and 1/2” nut (#3).
c. Adjust the tailwheel up or down to the desired cut-
ting height by repositioning the adjusting plate
(#4) and replace the attaching hardware.
Cutting Height
Figure 3-3
14391
Single Tailwheel Height Adjustment
Figure 3-4
14388