Filter
Top Products
11
Section 1 Assembly and Setup
7/14/08
RCR2584 Rotary Cutter 312-459M
Land Pride
Table of Contents
Axle Assembly
Refer to Figure 1-6:
1. Install tire (#1) to axle weldment (#2), using four bolts
(#3), lock washers (#4) and flat washers (#5).
2. Repeat for opposite side.
!
DANGER!
Rotary cutters have the ability to discharge objects at high
speeds; therefore, the use of front and rear safety shields is
strongly recommended when cutting along highways or in an
area where people may be present.
Safety Guards
Front Chain Guard
Install each segment of the front chain guards (#1) as
shown in Figure 1-7, with 1/2” -13 x 2 3/4” long carriage
bolts (#2), lock nuts (#3). Tighten all nuts and bolts to
torque as indicated in the “Torque Values Chart for
Common Bolt Sizes” on page 27.
Rear Chain Guard
Install each segment of the rear chain guards (#1) as
shown in Figure 1-8, using with 1/2” -13 x 1 1/2” long car-
riage bolts (#2), 1/2” flat washers (#3) and 1/2” lock nuts
(#4).“Torque Values Chart for Common Bolt Sizes” on
page 27.
NOTE: Do not tighten hardware until assembly
is complete. Refer to “Torque Values Chart for
Common Bolt Sizes” on page 27.
Axle Assembly
Figure 1-6
14387
Front Chain Guard
Figure 1-7
14382
Rear Chain Guard
Figure 1-8
14383