Filter
Top Products
18
Section 3 Adjustments
RCR2584 Rotary Cutter 312-459M 7/14/08
Land Pride
Table of Contents
Dual Tailwheel
Refer to Figure 3-5:
1. If the cutting height is too high or too low, the tailwheel
must be adjusted as follows:
a. Use the tractors 3-point hydraulic control to lift the
cutter such that the tailwheel clears the ground
surface.
b. Remove attaching hardware; 1/2” -13 x 3 1/2" long
bolt (#1), 1/2” lock washer (#2) and 1/2” nut (#3).
c. Adjust the tailwheel up or down to the desired cut-
ting height and replace the attaching hardware.
Dual Tailwheel Height Adjustment
Figure 3-5
14388
Trail-Type Lift Selections
The trail-type unit can be equipped with a ratchet jack (#1),
or hydraulic cylinder (#2). The hydraulic selection includes
stroke control spacers (#3) to set cutting height. Stroke
control spacers (#3) consist of cast steel halves and a
spring clip. To install or remove, simply raise or lower im-
plement with tractor hydraulics and pull stroke control
valves apart. Store stroke control spacers on hydraulic
hose (#4) near hydraulic cylinder. Refer to Figure 3-6.
Trail-Type Lift Selections
Figure 3-6
14390