Filter
Top Products
33
Section 5: Maintenance & Lubrication
2/02/08
RC5014 (540 RPM) and RCM5014 (1000 RPM) Rotary Cutters 330-117M
Land Pride
Table of Contents
Constant Velocity Driveline
Joints & Shields
Type of Lubrication: Multi-purpose Grease
• The constant velocity joint should be greased in a
straight position forcing grease through the passages
and into the cavity. After lubrication, grease should be
visible around the ball joints.
• The constant velocity driveline comes equipped with a
grease zerk in the outer telescoping member and must
be greased every 8 hours to prevent premature failure
of the joint.
• Grease fittings are located on the u-joints and driveline
shields and should be lubricated every 8 hours of
operation.
NOTE: To extend the life of the constant velocity
joint, extensive lubrication must be performed every
8 hours of operation.
15312
8
Hrs
23565
Drivelines with internal tube grease point
15312
23565
Drivelines with internal tube grease point
Zerk Located on end of tube
Constant Velocity Driveline Profile Tubes
Type of Lubrication: Multi-purpose Grease
Quantity = Coat Generously
20
Hrs
Drivelines with external tube grease point
Zerk located through slot in tubes
Drivelines with external tube grease point