Filter
Top Products
20
Section 3: Operating Instructions
RC5014 (540 RPM) and RCM5014 (1000 RPM) Rotary Cutters 330-117M 2/02/08
Land Pride
Table of Contents
Driveline Turning Angle
Refer to Figure 3-4 & Figure 3-5:
Plan your field cutting to minimize number of turns,
especially extreme turning angles. Avoid tractor-to-cutter
turning angles that exceeds the driveline’s maximum
turning angle. If the turn cannot be avoided, disengage
tractor PTO and wait for the driveline to stop rotating
before making the turn.
• Standard Conventional driveline:
Maximum turning angle = 35
o
.
• Constant velocity driveline:
Maximum turning angle = 80
o
.
Conventional U-Joint Driveline
Figure 3-4
Constant Velocity (CV) Driveline
Figure 3-5
General Operating Instructions
!
DANGER
Do not operate 14 ft. cutters without wing attached to the center
deck. Removing the wing will expose blades and increase risk of
cutter overturning. Exposed blades can result in serious injury
and/or death.
!
DANGER
Do not lift deck to use cutting blades as a fan. Cutting blades
are not properly designed or guarded for this use. Using the
deck as a fan can result in injury and/or death.
!
DANGER
Damaged drivelines can brake apart while rotating at high
speeds causing serious injury or death. Always remove Rotary
Cutter from service until damaged drivelines are repaired or
replaced.
11934
20795
!
DANGER
Do not engage tractor PTO while hooking-up and unhooking
the driveline or while someone is standing near a rotating
driveline. A person’s body and/or clothing can become
entangled in the driveline resulting in serious injury or death.
!
DANGER
Rotary cutters have the ability to discharge objects at high
speeds. To prevent personal injury caused by thrown objects,
the use of front & rear safety guards is strongly recommended!
!
WARNING
Tractor PTO shield, all Rotary Cutter gearbox shields and
driveline shields must be in place and secured while the cutter
is operating to avoid injury or death from entanglement in
rotating drivelines!
!
WARNING
Refer to Figure 5-3 on page 25. Keep all objects out of blade
bolt access hole “A” except when servicing cutter blades (#3).
Make sure the main driveline is disconnected from the tractor
before servicing cutter blades.
!
CAUTION
Do not exceed the rated cutting capacity of the cutter! See
Specifications and Capacities on page 35 for cutting capacity of
your specific unit. Using this cutter for any other type of work
can damage the drive components, cutter blades and deck
components!
!
CAUTION
Always disengage PTO, engage parking brake, shut tractor
engine off, remove switch key and wait for blades to come a
complete stop before dismounting from tractor.
!
CAUTION
Do not over speed PTO or machine damage may result. Many
tractors provide both 540 and 1,000 RPM PTO speeds. Check
your tractor’s manual to determine its capabilities.
• RC series cutters are designed for a tractor with 540 RPM
rear PTO.
• RCM series cutters are designed for a tractor with 1000
RPM rear PTO.
IMPORTANT: Avoid catching hydraulic hoses on
brush, post, stumps, and other protrusions that
could damage and/or break them.
NOTE: Your Rotary Cutter is equipped with free
swinging cutting blades to reduce shock loads when
striking obstacles. However, it is best to avoid
striking obstacles to extend cutter life and life of
cutting blades.