Land Pride RCM5014 Brush Cutter User Manual


 
31
Section 5: Maintenance & Lubrication
2/02/08
RC5014 (540 RPM) and RCM5014 (1000 RPM) Rotary Cutters 330-117M
Land Pride
Table of Contents
Divider Box
Type of Lubrication: 80-90W EP
Quantity = As required
NOTE: Do not overfill! Cutter should be level when
checking oil. If, for any reason, all oil has been removed
from gearbox, refill to level plug and allow air to bleed up
from lower cavity, then recheck.
8
Hrs
Gearbox
Make sure wings are down. Unscrew top vent plug in
gearbox to remove dipstick. Wipe oil from dipstick and
screw it back in without tightening. Unscrew dipstick and
check oil level mark. If low, fill through top plug hole in
gearbox with EP 80-90W oil until oil reaches full mark on
the dipstick. Reinstall vent plug with dipstick and tighten.
Take your gearbox to a Land Pride dealer if it requires
service.
Type of Lubrication: Gear Lube 80-90W EP
Quantity = Fill until oil reaches full mark on dipstick.
IMPORTANT: Do not overfill! Level cutter and wait
for gearbox oil to cool before checking. An unlevel
cutter or a gearbox with hot oil will not show correct
oil level on the dipstick.
8
Hrs
23582
Do Not
Overfill
Oil Level
Plug
23603
Oil Fill Plug
Oil Level Plug
Oil Drain Plug
24852
Oil Level Plug
Oil Fill & Vent Plug