Filter
Top Products
23
Section 4: Options
2/02/08
RC5014 (540 RPM) and RCM5014 (1000 RPM) Rotary Cutters 330-117M
Land Pride
Table of Contents
Hydraulic Accessories
Independently Controlled Deck Wings
Land Pride offers a kit for raising the deck wings
independently to clear small obstacles in the field without
maneuvering around them. Your tractor will require three
duplex outlets to raise the wings independently. If
needed, you can add duplex outlets to your tractor by
purchasing Land Pride’s 3 Spool Control Valve Kit or their
Selector Control Valve Kit. See “Duplex outlets” below if
additional outlets are required.
Part Number & Description
318-316A Hydraulic Wing Control Kit
Duplex outlets
Some tractors do not have enough duplex outlets to
handle the equipment connected to the tractor. Land
Pride offers the following kits to add duplex outlets to
your tractor.
3 Spool Control Valve Kit: This kit is for tractors with a
single duplex outlet. It converts the single duplex outlet
into three duplex outlets with three hydraulic controlled
levers.
Selector Control Valve Kit: This kit is for tractors
needing only one additional duplex outlet. It converts one
of the tractor’s duplex outlets into two duplex outlets with
a control valve. A selector switch on the control valve
selects which of the two duplex outlets is operational with
the tractor hydraulic control lever.
See your local Land Pride dealer if your tractor is not
properly equipped with the correct number of duplex
outlets.
Part Number & Description
312-315A 3 Spool Control Valve Kit
312-316A Selector Control Valve Kit
IMPORTANT: Never operate this cutter under any
terrain conditions where, on a continuous cut, the
wing angle exceeds 45 degrees up. Damage to the
wing driveline and gearboxes can occur. Raise wing
only to clear obstacles and then lower the wing
immediately after clearing the obstacles.
Follow all safety precautions in this manual
especially information regarding raising the wings up
with PTO running.
Hitch Options
Refer to “Hitch Types” on page 12
The cutter is factory supplied with the standard clevis
hitch. Also available is the Pintle Hitch. See “Hitch Types”
on page 12 for complete description of hitches.
Part Number & Description
330-336A Standard Clevis Hitch
330-337A Pintle Hitch (Optional)