Filter
Top Products
25
Section 3: Adjustments
ZT60i & ZT72i (S/N 748110+) Accu-Z
®
Zero Turn Mowers 357-552M
Table of Contents
2/06/14
c. Ensure cable adjustment allows linkage (#7) to
return fully to disengaged position. Not doing so
may cause premature wear and unnecessary
heat in the transaxle.
d. Move mower to an incline and recheck break lever
to make certain park breaks will hold mower on an
incline. If necessary, repeat step 5 until breaks will
hold on an incline.
Seat Reach Adjustment
Refer to Figure 3-2 & Figure 3-3:
The seat should be adjusted forward or rearward to a
comfortable position to operate the deck lift pedal.
1. With operator sitting in the seat, place his or her right
foot on the deck lift pedal.
2. Press down on the pedal as if to change the cutting
height to determine if the seat is too close to the
pedal, too far away, or at the correct distance.
3. If seat is at the correct distance, skip to “Deck Lift
Pedal Adjustment” below.
4. If seat needs adjusting, pull spring loaded seat latch
(#1) to the left and move seat forward or rearward to
a comfortable setting.
5. Release spring loaded seat latch and recheck your
reach from seat to deck lift pedal to make sure it is
comfortable.
6. If the operator is still uncomfortable with his or her
reach to the deck lift pedal, then adjust the deck lift
pedal as instructed below.
Suspension Seat Weight Adjustment
Refer to Figure 3-3:
The Suspension Set can be adjusted to accommodate
different weights to idividualize the operator’s own
comfort ride while mowing over uneven terrain.
1. Dial knob (#2) under the seat clockwise to
accommodate more weight and counterclockwise to
accommodate less weight.
Deck Lift Pedal Adjustment
Refer to Figure 3-4:
The deck lift pedal has three positions it can be adjusted
to suit operator comfort.
1. Loosen carriage bolt (#5). Do not remove.
2. Unscrew hex flange nut (#4) and remove carriage
bolt (#3) from lift arm (#2).
3. Rotate deck lift pedal to the preferred square hole
and reinsert carriage bolt (#3). Secure carriage bolt
with hex flange nut (#4).
4. Tighten 3/8"-16 x 1 1/4" GR5 carriage bolts (#3 & #5)
to the correct torque.
Deluxe Seat Reach Adjustment
Figure 3-2
Suspension Seat Reach Adjustment
Figure 3-3
Deck Lift Pedal Reach Adjustment
Figure 3-4
33773
33773
33774