Filter
Top Products
11
Section 1: Assembly & Set-up
ZT60i & ZT72i (S/N 748110+) Accu-Z
®
Zero Turn Mowers 357-552M
Table of Contents
2/06/14
Discharge Chute Assembly
Refer to Figure 1-2:
The Zero Turn Mower is shipped with carriage bolts (#2)
and hex flange locknuts (#3) attached to the deck in the
location shown. Remove carriage bolts from deck and
attach discharge chute to the deck as follows:
1. Attach discharge chute (#1) to the deck by inserting
3/8"-16 x 1" GR5 carriage bolts (#2) up through deck
bottom as shown.
2. Secure with hex flange locknuts (#3). Tighten lock
nuts to correct torque.
Seat Belt Assembly
Refer to Refer to Figure 1-3:
The seat belt is factory assembled when seat is shipped
attached to the mower. Seats lag screwed to the crate
will need the seat belt assembled to the seat.
1. Insert seat belt clip (#4) with push button “A” into clip
sleeve (#5).
2. Make sure push button “A” is facing out as shown.
Insert 7/16" bolt (#1A) through flat washer (#3), seat
belt clip & sleeve (#4 & #5), mounting hole “B” and
flat washer (#3). Secure bolt with nylock nut (#2).
Rotate seat belt up to the approximate angle shown
and tighten nylock nut to 36 ft-lbs. of torque.
3. Orient seat belt retractor (#6) with spring retractor
facing out as shown. Insert 7/16" bolt (#1B) through
flat washer (#3), mounting hole “C”, seat belt
retractor (#6) and flat washer (#3). Secure bolt with
nylock nut (#2). Rotate seat belt retractor to the
approximate angle shown and tighten nylock nut to
36 ft-lbs. of torque.
Discharge Chute Assembly
Figure 1-2
Seat Belt Assembly (Deluxe Seat Shown)
Suspension Seat Includes Seat Belt Mounting holes (B)
Figure 1-3
33765
30213
Seat Belt Retractor (#6) Must Be Mounted This
Side Of Mounting Hole “C” To Keep Retractor
From Interfering With Right Side Fuel Tank.
Spring Retractor