Filter
Top Products
PRECAUTIONS
This equipment is supplied by a mains voltage that can cause electric shock injury!
The following special limitations must be observed in order to maintain safety and electromagnetic compatibility
performance.
Power
The internal power supply is a switch mode type that
automatically senses the incoming mains voltage and will
work where the nominal voltage is in the range 100V a.c.
to 240V a.c.
A single, fused IEC mains inlet is provided on the rear
panel. The correct lead for connection in the area to
which the unit was shipped is supplied with the unit. The
equipment should only be plugged into the mains outlet
using the supplied lead.
When removing the equipment’s electric plug from an
outlet, always hold the plug itself and not the cable, as
pulling out the plug by the cable can damage it, and never
insert or remove an electric plug with wet hands.
Grounding
In the event of ground loop problems, use the earth LIFT
switches provided on both sets of outputs (rear panel). If
you have ground loop problems relating to the inputs, use
a DI box, for example, Klark Teknik’s DN100, to provide
isolation.
Handling the equipment
Before moving the equipment, disconnect it from the
mains, and when lifting or moving it, always take its size
and weight into consideration.
Avoid inserting or dropping foreign objects, such as paper,
plastic, metal etc., into any gaps or openings on the
equipment, for example, vents. If this happens, turn off
the power immediately and unplug the power from the
a.c. outlet. Then have the equipment inspected by the
manufacturer's qualified service personnel.
Installation
Before installing and connecting up the equipment, check
that both the mains supply and the quality of earthing are
adequate for the equipment. Also check that the mains
power supply voltage rating corresponds with the local
mains power supply and that the mains fuse is of the
correct type and rating.
Unless advised otherwise, optional equipment must only
be installed by service personnel and in accordance with
the appropriate assembly and usage regulations.
Location
Ideally, a cool, well ventilated area is preferred, away
from power distribution equipment or other potential
sources of interference. Do not install this equipment in a
location subjected to excessive heat, dust or mechanical
vibration and keep the equipment out of direct sunlight.
Where necessary use fan cooled racks.
This unit is only intended for rack mounting.
Audio connections
To ensure the correct and reliable operation of your
Square ONE Splitter, only high quality balanced,
screened, twisted pair audio cable should be used. XLR
connector shells should be of metal construction so that
they provide a screen when connected to the unit and
should have Pin 1 connected to the cable screen.
DOC02-SQ1SPLITTER_Square ONE Splitter_Op_IssC.pdf 9 27/04/2010 17:00:42