Filter
Top Products
Getting started
Square ONE Splitter 7
Connecting the power cable
Making sure that the mains power at the power outlet is off, connect the mains cable supplied with your
Square ONE Splitter to the mains power outlet and then to the mains socket at the rear of your unit.
Connecting the audio cables
Making sure that all equipment is switched off, connect your Square ONE Splitter to the rest of your audio
equipment as shown in the following subsections.
The mic preamp gain may be adjusted using the GAIN control knob, the gain range being adequate to
accommodate most mics, keyboards, DI boxes, backline preamp outputs and active guitar/basses. However,
passive guitars require a high impedance load and should be connected via a suitable active DI box, such as
the Klark Teknik DN100.
Channel I/O pin-outs
The following diagram shows the pin-outs for both the male and female chassis connectors on the Square
ONE Splitter, when connecting to balanced equipment.
Figure 2: I/O connections to balanced devices
1
3
2
2
1
Pin 1: Screen/Ground
Pin 2: Hot signal
Pin 3: Cold signal
Pin 3: Cold signal
Pin 1: Screen/Ground
Pin 2: Hot signal
3
Male XLR
chassis
connector
Female XLR
chassis
connector
Ground
+ve
-ve
Ground
-ve
+ve
Balanced device
DOC02-SQ1SPLITTER_Square ONE Splitter_Op_IssC.pdf 19 27/04/2010 17:00:42